top of page
Schematics
This is the schematic that encapsulates the headers for plugging into the FRDM-KL25Z Micro controller, the connections for the four motors and their Hall Effect sensors, along with the Bluetooth module, and the motor drivers.
This is the schematic that encapsulates the voltage regulator from the battery that runs the voltage level converters that runs the Hall Effect sensors. It also has the connections from the motors that run to the main board as well.
Test Points
These are the test points that students will be able to connect to with either a Digital Multi-meter, Oscilloscope, or another lab device.
Printed Circuit Boards
Main Board Layout
This is the printed circuit board that steps down the voltage from the battery so it is a safe voltage to operate the Hall Effect sensors at. This also has the connections from the car that run to the main board as well
bottom of page